hi guys.. im new.. and I hope im in the right thread. I got a set of decah hinges from my brother . and I was wondering if someone can tell me how to roll the fenders????? or what ever that means..??? any information would be good...also.. anyone have a write up here for installation of these hinges???? thanks a million..

this site rocks btw!!!

If you are talking about the lambo door hinges... I am not sure how to rool the fenders.

The only fender rolling Ive heard of pertains to the rear, small lip on the inside edge to prevent tire rub.

Take pics of those hinges....tons of people are wanting to see them

______________________________

Ryan
IRyanHester@Hotmail.com

'03 Mazda 6s

ill get a camera and take some... but anyone else have lambo doors??? I think im gonna need help with this install. but Im stumped with the whole rolling fenders thing... im only 19 btw. anyone else care to share some advice??? i check this board often..

thanks..

p/s....... is this install gonna be a P.I.T.A????????

Rolling the fenders has to do with lowering you car and putting different tires on and preventing rub. It has nothing to do with putting on door hinges.



forums.2gnt.com/dcboard.php?az=show_topic&forum=12&topic_id=13280&mesg_id=13280&page=
Current Status: Specifications Made

Ive read the doors will hit the fenders when opened up all the way. Just put them on and then bend the fender out of the way where it hits when you open it. I think its the inside of the fender where the front of the door meets it near the top. Dont hold me to that cause ive never seen lambo doors in person.

_______________________________________
The end of the internet begins here... www.broke-off.com