i've got a question about taking apart altezas, how can i do it?

i was thinking the same way as the headlights but i wanna be sure before i go and roast them lol

i need to take them apart to glue the red lense back on, and while i'm in there i'm gonna paint them to match the car.

i think that would look hot

well any suggestions or a how to will be appreciated
tia

WTB--- Dodge Omni:


http://www.geocities.com/shadyporshe851proof/frame_content/indexframe.html

mods:
star stage III clutch, + the normal mods + bass + lights. well u get the pictur

yeah, just like headlights but are a tad more sensitive to heat than the headlights. I'm guessing thinner plastic. I had my sister's apart but I accidently warped an edge. You can't see it, but I would really watch them in the oven and have it set to the lowest heat setting.

Shit is all apart. Typical...

>yeah, just like headlights but are a tad more sensitive to
>heat than the headlights. I'm guessing thinner plastic. I
>had my sister's apart but I accidently warped an edge. You
>can't see it, but I would really watch them in the oven and
>have it set to the lowest heat setting.

Do what he said.. Don't spends hours trying to pry off the glue with a screwdriver like I di

_____________________________
1994 Mitsubishi 3000GT VR-4
1990 Plymouth Laser RS Turbo
http://www.laser-eclipse.net


1999 Mitsubishi Eclipse GS -Sold, I miss it

ok, but can u be a little more specific about the steps on how to do it in the oven? it's been so long since i read about doin' the headlights i don't remember...

tia

WTB--- Dodge Omni:


http://www.geocities.com/shadyporshe851proof/frame_content/indexframe.html

mods:
star stage III clutch, + the normal mods + bass + lights. well u get the pictur

bumpity bump bump bump :0

WTB--- Dodge Omni:


http://www.geocities.com/shadyporshe851proof/frame_content/indexframe.html

mods:
star stage III clutch, + the normal mods + bass + lights. well u get the pictur

set the oven to like 200 degrees and check on them often. i warped one side when i tried it. and dont try and pry them apart if the glue isnt melted, you will crack the clear plastic piece (dont ask my how i know). maybe try a heat gun if you can get a hold of one. but it can be done in the oven...just dont set the heat too high.