So, a while back I tried to take out one of the door window vents. I just busted off some of the plastic, and let it alone. Now, I want to finish what I was doing. How do you remove those things? I wasn't sure if they were screwed in or just pressure fit or whatever. Any tips?

juan

if i remember correctly, they are screwed in with those cheap nuts...they are made out of flat steel and are threaded kinda onto lil plastic posts. you have to completely remove the door skins. same way for the defroster vents in the doors too..they are held by the same lil nuts. oh, and i think there are about 3-4 phillips head screws you gotta take out too. hope this helps!

-----------------------------------------
2011 Nissan Xterra Pro-4x

2007 Kawasaki Ninja 650R

1996 Mitsubishi Eclipse RS-NX 75 shot, AEM CAI, P&P t/b and intake mani-SOLD

1964 Buick Electra 225-all original, all power options, 325hp, 445ft/lbs tq

^^^^^ You are correct you must remove the whole door panel to remove the vents...Icracked one of minea year ago.....ANYONE have an extra??

It's a major Pain in the ass Juan. You need very very small screwdrivers, some of them bent at a 90* angle and used more like a wrench. Just took those out of a buddy's car and it sucked ass!

Its not hard Juan...just gotta remove a lot of stuff just to get those out.

----------------------------------------------------------------------------
home.comcast.net/~nappyjim/songs.html
home.comcast.net/~7291834avi/carputer/carputer.html
www.cardomain.com/id/napppyjim

*Proud Member of the Top Ten Post Whore Club*
*Proud And Co-Founding Member Of The Zoom Zoom Revolution*
nappyjim-3 Chip-0
No one likes you chip, go away.

Oh gezz,
I hope that wasn't directed towards me. I have poor grammer skills, I apologize if so. And sometimes my fingers get away from m