#4155, "Headlight off, HOW DO I GET IT OFF THE CAR!?!"
Hey, I tried to get my front bumper and headlights off, so I used Cyan's guide (thanks Cyan). Everything was off including the hard to get to bolts underneath the headlights, so the lamps were completely free to move around, but the bumper and fender were too close together for me to pull the headlight out. The wire plug thing was in the way (it's on the bottom). How do I get the headlight off? I can't get the bumper off because there are 2 (1 on each side)plastic expanding screw things underneath the lamps that I can't get too unless the lamp is out, so I'm stuck either way.
Help please, thanks
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob Trust EVO Exhaust AutoMeter A/F Ratio Gauge 'tis it
#4156, "RE: Headlight off, HOW DO I GET IT OFF THE CAR!?!" In response to Reply # 0
if you took out allthe bolts and screws off the top sides and bottom all you have to do is take take out the bolts for the bumper support. if you look inthe center oppening you will se the bolts hoding the brakets for the big support beam that s behinfd the bumper cover. the bumper is attached to this by a screw or clip that is hidden under the headlights if you get the bolts out it will com right off. also dont feel bad it took me about 2 hours of struggling to figure this out.
#4157, "RE: Headlight off, HOW DO I GET IT OFF THE CAR!?!" In response to Reply # 1
haha.. Yeah, same here, took me about 2 hours too just to figure out how to get those damn things out.. not as easy as it looks at first sight.
Josh 95 Eclipse RS Bosch Platinum+ Plugs Blue Lightning Plug Wires Clear Corners and Bumpers Hyper Whites all around Rediculous Stereo All Blue Interior Lighting And last but not least, Unbelievable wheel hop on them right hand corners!
1998 Mitsubishi Eclipse GS-T Evo Front Bumper (no pics yet) Projector Headlights Clear Corners Stereo System -Alpine Deck -2 JL 10" Subs -Phoenix Gold XS2300 Amp -Custom Fit Box Viper Alarm
#4158, "RE: Headlight off, HOW DO I GET IT OFF THE CAR!?!" In response to Reply # 0
Probably best to remove the front bumper. The main supports for the front bumper are in the frame railing rught underneath and behind where the headlights are. If you jack the car up, you can see 2 holes on each side of the frame with bolts that hold the bumper brackets in place. remove these 4 bolts, and remove the 4 bolts that connect the front bumper to the fender, and all the little bolts under the front bumper and on top, and it should slide right off.
#4159, "RE: Headlight off, HOW DO I GET IT OFF THE CAR!?!" In response to Reply # 3
Ok I finally did it. Not exactly what you guys were talking about but, there were 2 plastic expanding screw things under EACH headlight facing DOWN?!?!?!? GHAAA how are you supposed to get a screw driver in there and unscrew them? There's about 1/4 of an inch space. So's I ripped the shit outta them and the bumper came off, see my problem was I couldn't get the headlight out to get to the screws and couldn't get the bumper off to get the headlights out so.... Thanks anyways guys. I got rid of all the ugly black plastic crap and put in some Diamond Lath, it's used for stucco. I work at Home Depot so I got da connection, hehe. Looks good, just gotta paint the mesh.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob Trust EVO Exhaust AutoMeter A/F Ratio Gauge 'tis it
#4160, "RE: Headlight off, HOW DO I GET IT OFF THE CAR!?!" In response to Reply # 4
yeha i was gonna say just get a jigsaw in there and cut off the tabs that hold the bumper on under the lights. or break off the bracket for the bottom headlight bolt. just remember, its now a 5 minute operation, youve done the hard part already
______________________________ If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.
'95 Eclipse TurboGS (garage deco) '95 TSi AWD (restoring a survivor) '97 Talon ESi-T (poor impulse control) '99 Eclipse RS-T (daily beater) '13 Evo X (mostly stock) '17 Sienna (Middle Aged Dad Mobile)
#4162, "RE: When i did my intercooler install..." In response to Reply # 6
Dude, all I have holding the bumper on now are the 2 bolts on each fender and the 5 on top (under the hood) nothing else. It doesn't sag or anything and looks perfect. Cyan's right, now I think it would LITERALLY take me less than 15 mins to get completely off.
Thanks, guys/gals
PS, I removed it so I could put some mesh in there. It looks cool but I need to paint the mesh, it's silver and looks pretty weird. Maybe I'll get pics.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar AutoMeter A/F Ratio Gauge 'tis it
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar AutoMeter A/F Ratio Gauge 'tis it
Search
Printer-friendly copy
0 Users in Chat
