What size drill bit do i need to make holes for those plastic screws that pop into place on the sideskirts. 97-99

----------------------------------------------------------------------------
home.comcast.net/~nappyjim/songs.html
home.comcast.net/~7291834avi/carputer/carputer.html
www.cardomain.com/id/napppyjim

*Proud Member of the Top Ten Post Whore Club*
*Proud And Co-Founding Member Of The Zoom Zoom Revolution*
nappyjim-3 Chip-0
No one likes you chip, go away.

I think the exact drill size is jb weld. Yup.

I got banned for being a constant tard.

just use a bit that is as close to the diameter of the grommet. a little smaller, but nothing bigger

I did that just a few weeks ago. Chose a good size and drilled. Then I went to pop the grommet in and the whole grommet fell off. Happened with all grommets. Hence my jb weld comment. Now I just have holes under the skirts for no reason

I got banned for being a constant tard.