Im so fukin pissed! # F'n hours and I still dont have my damn wires run threw the damn door!!!!!!! My hands are bleeding, back is messed up and I am gana kill someone!!!! Installing my turbo was easyer than runing the damn wires!!! I have a powerwindow kit and I have to run the wires threw the doors and I cant get them threw the damn car! I unscrewed the damn plastick harness that is in the way and it still is in my way, I have to get about 3/4 inch of wires and there is still no room and Im gana !@#$!#@#!$%$#! Dose n e one have a trick or know how I can do this without takin my dash out?!

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

put em thru ur firewall yo. I have my friend help me. Somehow he got a drill down in the engine and my the holes bigger to fit the wires.

----------------------------------------------------------------------------
home.comcast.net/~nappyjim/songs.html
home.comcast.net/~7291834avi/carputer/carputer.html
www.cardomain.com/id/napppyjim

*Proud Member of the Top Ten Post Whore Club*
*Proud And Co-Founding Member Of The Zoom Zoom Revolution*
nappyjim-3 Chip-0
No one likes you chip, go away.

did you try feeding them through wire by wire instead of all together?? What i used to do was tape a wire to a straightened out coat hanger and force the wire through, then undo it at the other end. 1 by 1.
-johnny

"Few people understand
the psychology of dealing
with a highway traffic cop.
Normal speeders will panic
and immidiately pull over to
the side. This is wrong. It
arouses content in the cop
heart. Make the bastard
chase you, he will follow..."

http://homepage.mac.com/
johnnycorona/signature/logo.jpg

-johnny

"Few people understand
the psychology of dealing
with a highway traffic cop.
Normal speeders will panic
and immidiately pull over to
the side. This is wrong. It
arouses co

What ^^^^ said.

http://www.snappydsl.net/ctoledo/

well Ive calmed down a bit so I think Im gana have to do that or some thin simaler, never new it would be so hard to feed a 1" wire threw a 3" hole?

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

Get a coat hanger, and tape the wire on the end coat hanger. Take out the speaker pod, and just pull through. The rubber shoe can be pulled out on the door temporary so u can guide the coat hanger through the rubber boot. Next part is getting it inside the car, same deal. I ran 8 guage wire like this... so dunno about 1"

Oh, to get it in the car, u have to remove the bottom part of your dash. But just the bottom part, comes off with 2 bolts. (Where hood pin is hooked to) This makes it a little easier. Also, try not to "force" it in, might break some wires.