What did you all do to reseal up your tail lights after you pulled them apart and painted them? Should I silocone in the gaps and reattach the clear plastic shield or just reattach it and put it in the oven until the old silcone or whatever they use gets soft and reseals that way? tia

before


after


sorry pics aren't showing up...
if someone will host them that would be great.

--------------------


- 05 Subaru STi
- 97 eclipse gs (289whp w/ 276tq)

i just used the old stuff i did not put any new crap in there but if u want to play it safe but new crap in there then heat it up then seal it up and whip cream it up....

I used clear siliy cone

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

Thx...btw did you dig out the old first?

--------------------


- 05 Subaru STi
- 97 eclipse gs (289whp w/ 276tq)

no what I did was heat it up with a heat gun so glue heated up, than I put more so it will seal beter

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

I put the clear plastic lenses on and put them in the oven...then removed them and pressed them together again. Hope it works. I won't be able to tell until my car gets out of the shop. And then it will have to go right back in again. I hate when my car is broke.

--------------------


- 05 Subaru STi
- 97 eclipse gs (289whp w/ 276tq)

This should work...

before:


after:

--------------------


- 05 Subaru STi
- 97 eclipse gs (289whp w/ 276tq)

looks good, welcome to the no crome altezzas club

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/