Is there anything special to take into consideration when hooking up LED's if I wanted them to come on with parking lights?? or is it just power and a ground?

Brandon
'95 GS, Auto.
AEM Cold Air w/ bypass valve
Front Upper Strut Brace
Maxspeed coilovers

You'll need a ressitor otherwise you'll burn it out. Most LED are rated for about 5V.

To figure out what resistor you need use this formula:

(Vcar-Vled)/Aled = R

Vcar is the Voltage of the car, assume 14V to me on the safe side.

Vled is the Voltage the led is rated to (you'll find it on the package)

Aled is the amp rating in Amps of the LED (also on the package and remmember 1mA =.001A)

R is the resistor you'll need in Ohms. You won't find a perfect match so use the resistor that's closest.

Keep in mind that the bigger the resistor the dimmer the LED will be, but you use to small of a resistor you could burn it out.

-J

I use 330 ohm usually.

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayamaprojectors /WW 3 pieces wing/interior mods

Ken


5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(fron

330 ohms will probably work, but not all LEDs have the same ratings.

-J

what ^ said is right tho. I used ordinary Radio Shack Led.

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayamaprojectors /WW 3 pieces wing/interior mods

Ken


5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(fron

where's the resistor go... power or ground side?

Brandon
'95 GS, Auto.
AEM Cold Air w/ bypass valve
Front Upper Strut Brace
Maxspeed coilovers

according to hondahater, it shd weld on poistive side(the longer wire)

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayamaprojectors /WW 3 pieces wing/interior mods

Ken


5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(fron