much like hondahater.....after much cursing, kicking, and damning the metal to hell, i finally got it to fit. My first prob was a metal piece that hooked from the slider to the bracket was to big to fit thru the bracket hole. So to make the bracekt hole biggerm i used a drill bit, a drill with some rough ass sanding cone thing on it, and a saw.. I finally got it big enuff. Then i put the sliders on then the seat, but the seat was wayyyy to high. Im around 6'3 and my head was hittin the ceiling. Lucckily, the metal part on the slider that get bolted on the bracket had 3 separte holes, so i went and sawed of 2 of the holes so i could get it as low as possible. Then my screws woudlent fit in the holes right, bu i put them in good enuff to hold it. Finally, i got the seat on, and it looks pimped.

But i dont think the sliders are on the way they are "supposed" to be on. Cause i did way to much hammering metal back and sawing then i think anyone should. So i didnt do it right, but hey, it works. time to update the sig!


18" Konig Tantrum Rims
Yokohama Parada Tires
H&R Sport
$15 Rear Camber Mod
AEM Cold Air Intake
ACS Black Molded Carpet
Interior Painted Silver/Black
Hyperwhite Lights
2 Rockford Fosgate XLC Subs
750 Watt All Digital Amp
Reverse Indiglo Gauges
NGK Spark Plugs
No Name Muffler

Soon To Have:
Tenzo R Seats
HVAC Mod

----------------------------------------------------------------------------
home.comcast.net/~nappyjim/songs.html
home.comcast.net/~7291834avi/carputer/carputer.html
www.cardomain.com/id/napppyjim

*Proud Member of the Top Ten Post Whore Club*
*Proud And Co-Founding Member Of The Zoom Zoom Revolution*
nappyjim-3 Chip-0
No one likes you chip, go away.