i recently got a 22 piece carbon fiber kit which includes the gauge bezel..i tried to get to my guages by taking out the two screws on the top which made it loose but i didnt want to force it is there anything else i have to unscrew or loosen could someone tell me thanks

All you need to remove are the two upper screws. The thing is actually stapped in place. Pull on it real hard and it will come out. Once that is out, remove the fours screws that hold the gauge cluster in.....then pull the cluster straight out (it plugs in place). Then just remove the clear plastic off the cluster.

http://www.cardomain.com/ride/3130861

Last week I installed a set of indiglos and painted my bezel yellow, I had to remove the steering wheel, column cover and then do all that...I tried otherwise it didnt seem to have enough room so I ripped all that stuff out.

I'm not retarded....I'm a very special boy.



96 ESI - 97 - 99 Projectors, full blitz kit dodge viper race yellow, combat wing, painted altezza's, OZ 17's in scorcher TA's// HRC Stage II, True 3" all the way back. Symborski, CF clutch, AGX adj, spor

i took out my bezzel w/o removing the steering wheel, you just have to wiggle it a lil bit.

-bryan
'98 rst

yea.. you dont have to remove the steering column.. like john said.. two screws, pull off the outter piece.. four more screws after that, and the whole thing should come out after that.

^^what once was^^


^^what is now.. and permanently^^