So am trying to get the door locks working properly. I've just replaced a busted handle, but the mechanism itself was also acting wonky.

After some effort I extracted the whole mechanism from the door.



Any suggestions on how to test it to make sure its working properly?
(assuming that I didn't wreck it in the process of getting it out, which was a btch to do...)

I was going to de-gunk it with some sort of aerosol cleaner and then lube it back up before re-installing it. I've cracked open the motor housing, and it looks pretty good in there (no dirt the screw mechanism seems in good shape).

thx,
juan

I don't remember the wiring, but when the door locks stop working they usually just need a good cleaning of the moving parts or the connector contacts (e.g, the internal motor is not at fault.)

Those things are a major PITA to remove, but there is a technique to pulling them out of the outside of the door.

2gnt: '99 RS-T, killed by a toyota, pending rebuild...
Daily: Volt
Daily #2: '99 EVG ebike- STOLEN by PEDRO