hey guys, i took the lambo hinges off since the drivers strut is messed up, and i put the stock hinges back on and the passenger is fine but the drivers side just will not align right. when i open the door, you can see it drop down a little, and it you try to shut it, it just hits, you have to lift up on it a little, maybe 1/4 inch or so to get it to go. i do not have the little door strap that goes inbetween the hinges, i wonder if i need this? anyone have any suggestions what i should try to do? thanks alot guys

You know when you open the door so far it kinda locks into place, push it a little further and it locks again? That's all that black middle hinge does. You could try loosening the hinge bolts on the body and put a jack under the edge of the door, raise and tighten.

yeah thats what im gonna do, gotta get a buddy to help me to make it easier haha

our doors are long and heavy enough that trying to align them is a pain (not as much as a 250# jaguar door though)

get some help aligning it, an extra pair or two of hands makes a big difference

Erik P.
Official 2GNT thread Hijacker
Some say that he's driven over more Covenant than he's shot, and that his grenades aren't where you'd expect them to be...
All we know is, He's not The Stig... But he is The Stig's Spartan cousin!

yeah man for sure. im gonna get some buddies over hopefully sunday and get it done

I have the same prob but come to find out my bottom hinge has a broken head off of the bottom bolt and has a crack in the area where the hinge meets the frame. Guess I have to get it welded?? Any suggestions?

Looking for some DSMers in the area, Bernville, PA !!



I KNOW I CAN MAKE THIS EVEN FASTER!!!
I DRIVE IT LIKE I OWN IT!

MSD Wires, MSD Coil, Cold Air Intake, 4-2-1 Racing Header, EGR Block Off, Drilled Front Rotors, Venom 400 PCM, F-RU-RL Strut Bars, HID's, Autometer A/F, Volt, Oil Temp and Oil Pressure Gauges, 17x7.5 ROH wheels with Nankang 215-40-17's... Not installed yet: 2" Lowering Springs, Manual Conversion w/ Short Shift Kit and Steel Bushings for Cables and Base, 2.4L Swap, "Worked" 2.0L Head, 57.5mm ATX TB from TB.com, 1/2 Rad Mod, Poly Motor Mounts, Turbo Setup.