I am not sure if this in the right spot or not(please move if it isn't). But i am in need of a good body shop to take on a number of projects for my car. I have had some experience with some of the local shops and i did not like their work nor there customer support, hence why i am ask the community.

I know there is a number of you guys from this area, so I would be great full for any insite into this matter.

thanks,
kevin
aka susafuss

ps. i am from the Joliet/Shorewood area so it would be nice that this is not too far away, though i wouldn't mind if the place comes highly recommended.

___________________________________________________________________________
13psi on a built bottom end with a stock now mtx, check mate.

I've used these guys before they beat the pants off any other quote I got and they do great work.

http://www.performancerestorations.com/


also Deerpark Collision in Palatine has done my families accident cars for years..

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Thanks i will check both of those places out. Also mcgyvr i didn't know you were located in the chicagoland area.

___________________________________________________________________________
13psi on a built bottom end with a stock now mtx, check mate.

Autobody by Daniels right here in Plainfield but your going to pay out the ass. Daniel's work is top notch. He did all the work on my z28 and I loved the quality.

I will look into them too, thanks terry. It never hurts to just get an estimate on things.

___________________________________________________________________________
13psi on a built bottom end with a stock now mtx, check mate.

Thats not your car i saw with the dent in the rear end was it?

Nope, thats not my car.

The work the needs to be done is to have the rocker panels replaced, it would appear that merlin mufflers didn't put my car on the lift right and punched a hole in the bottom of the car and now its all rusted.

Then i got a set of gsx sides (that where lenghted to fit) to put on and painted

___________________________________________________________________________
13psi on a built bottom end with a stock now mtx, check mate.