#42642, "installiin 97 skirts...i searched too!" Mar-15-03 03:08 AM by nappyjim
ok i searched and read previous post....but they did not answer but size drill but is needed for those plastic popper screws? And are those called grommets...or are grommets something else?
*Proud Member of the Top Ten Post Whore Club* *Proud And Co-Founding Member Of The Zoom Zoom Revolution* nappyjim-3 Chip-0 No one likes you chip, go away.
#42645, "RE: installiin 97 skirts...i searched too!" In response to Reply # 0
yes the plastic pieces are the grommets... and for the bit size, just make sure that the bit is smaller than the gromet... im sure there is an actual size, but i didnt use the grommets when i installed mine, so i cannot give you an exact.
#42646, "RE: installiin 97 skirts...i searched too!" In response to Reply # 1 Mar-15-03 04:17 AM by nappyjim
thanks C. how did u hold the top part down then? with tape?
and i figured out the size. Just went from small to big in a piece of wood and tested the grommet in each size. It will go into some small holes but when i pulled it out...it cracked. So i went bigger and found a good size. 19/64 works good. Grommet wont pop in unless good pressure is applied so im sure it wont pop out. And when it does come out it doesnt brake.
I kinda like no door caps...gives it more a sleeker look, imo. But who knows...i might change my mind.
One more question....if i buy aftermarket skirts...will there gromments be spaced like stock ones so i dont gotta drill new holes?
*Proud Member of the Top Ten Post Whore Club* *Proud And Co-Founding Member Of The Zoom Zoom Revolution* nappyjim-3 Chip-0 No one likes you chip, go away.
*Proud Member of the Top Ten Post Whore Club* *Proud And Co-Founding Member Of The Zoom Zoom Revolution* nappyjim-3 Chip-0 No one likes you chip, go away.
#42681, "RE: installiin 97 skirts...i searched too!" In response to Reply # 4
>>thanks C. how did u hold the top part down then? with tape?
the top part is a bitch to get to stay down.. most of us that installed them ourselves just used double sided tape.. i also used strong ass velcro (ghetto i know, but anything to get those damn things to stay up there). you could get some more grommets and drill into the side of your car, but that is tricky.
>>and i figured out the size. Just went from small to big in a piece of wood and tested the grommet in each size. It will go into some small holes but when i pulled it out...it cracked. So i went bigger and found a good size. 19/64 works good. Grommet wont pop in unless good pressure is applied so im sure it wont pop out. And when it does come out it doesnt brake.
good stuff.. you should be fine.
>>I kinda like no door caps...gives it more a sleeker look, imo. But who knows...i might change my mind.
hehe... so do i, can you tell?
>>One more question....if i buy aftermarket skirts...will there gromments be spaced like stock ones so i dont gotta drill new holes
aftermarket skirts dont come predrilled (to my knowledge), so you can match them to your existing holes.