Looking to get the 22mm rear sway bar to tame some of the understeer but progress has delayed this item.

Summit Racing checked with Progress and they said it was "in the works", but i think with alittle 2gnt help we can get it for summmer!!

THis is alot bigger then the crappy suspension techniques sway bar, so it'll neutralize some of the understeer and make the car handle tons better.

For now i will settle for urethane bushings on the stock 13mm sway bar but i would appreciate if you all help me get Progress to not forget that we are all waiting for better parts for our 2gnts and 2gTUrbos!!!

Thanks

me with A-10's Avenger Cannon- can you say depleted uranium rounds?

www.blackjupiter.com (gaming computers - tell everyone you know!)
MODS:

Engine= 60mm TB, Greddy 4-1 Headers, AEM Short Ram, MSD Wires,

I have their number (Progress's) lying around, limme find it and ill post it, or call summit racing they have it too!

me with A-10's Avenger Cannon- can you say depleted uranium rounds?

www.blackjupiter.com (gaming computers - tell everyone you know!)
MODS:

Engine= 60mm TB, Greddy 4-1 Headers, AEM Short Ram, MSD Wires,

...I would be VERY careful just oredering the rear. Just a few mm over can send you tail into a swing like you never thought possible. I can fling my tail an will and run 21mm in the front and back. I don't know how good a driver you are but it is something to consider. I like being able to pass a car HARD on the outside and not worry about losing my tail. I'm able to do this because of my Illumina adjustment (Hard in front soft in the rear). Also remember that sway bars are ususally purchased as part of a set unless you've had experience with them

*Skrilla
"Honest officer, I thought you were trying to race me"
Talon: 1st 2.4L
'97 Prelude
'04 350Z

Originally posted by etx
Good luck man! Project 'STFU Brian your talon is dead meat' should be on it's feet soon!

What brand sway bars do you have??

me with A-10's Avenger Cannon- can you say depleted uranium rounds?

www.blackjupiter.com (gaming computers - tell everyone you know!)
MODS:

Engine= 60mm TB, Greddy 4-1 Headers, AEM Short Ram, MSD Wires,

...the www.RMDSM.com GSX sway bars. I feel that the Progess SET are the better bars but they are stiff and 22mm, so the driver should be experienced. I'm lazy sometimes with my driving so I will eventually get the front progress for less body roll and more understeer than what I have.

*Skrilla
"Honest officer, I thought you were trying to race me"
Talon: 1st 2.4L
'97 Prelude
'04 350Z

Originally posted by etx
Good luck man! Project 'STFU Brian your talon is dead meat' should be on it's feet soon!