Well I went to my local hardware stores to get the parts needed for the 15 camber fix and they seemed to both offer me shit that was just too small. I dont know if they didn't read the measurements right or what cause I gave them the sheet but I just didnt buy cause It just didn't look right. I want to go back knowing specifically what I need. I know that the mod section has a list but can anyone just tell me what I need in even more detail. Like what the numbers stand for and the M. if you can help me out that would be greatly appreciated. Thanks.

10mm(millimeter) by 40mm(millimeter) by 1.25( this is the thread pitch of the bolt, you MUST have 1.25! As you can see the bolts are all metric, which makes them harder to find. Just be sure the bolt specs are 10mm x 40 mm x 1.25, and you will be set. Grade 8.8 or higher is preferred. Yeah, the bolts look kinda small, but thats what mitsu uses on the rear mounting plate..

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)