aight, i get a small scratchin sound when im cummin to a stop. it isnt noticeable when im lettin the engine slow her down, but w/clutch in, and radio down, i can hear sumthin like metal scrapin. i just put MM pads up front, and im gunna check the rears soon enuff.

just wonderin if yall think its that arm that rests on the pad rubbin on sumthin???
or any ideas???

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki

Did you replace your rotors with new or did you machine your old ones??? If you didn't do either, the pad will NOT wear in properly with the already worn rotor. This could cause squeeling and bad braking...

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)

i only swapped the pads. the front rotors didnt look messed up/worn at all. at 30k when i had oem pads swapped in at a shop, i dont think they did anything either.


thanks for the insight

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki