so i took apart my driver side suspension and i got a axel puller and i broke my socket, the axel puller will not remover the axel, so being frusterated i hit it with a hammer, wont go back... i needed a new axel anyways so i dont care... why wont it budge?

im trying to remove the motor and trans so i can rebuild the whore

Wrong puller. I have an axle puller From Snap-on...CJ129 i think. It has removed axles that even a 40 ton press wont remove.

They are stuck because the splines rusted from moisture.

they are rusted, ill give you that... is this puller available to yank my shit out, its the only think i need removed to remove the engine...

sorry i havent called you back, i have been swamped. The puller is about 160.00 and it should be available from Snap-on

edit: here you go

http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=76459&group_ID=2248&store=snapon-store&dir=catalog

You def want an impact to make it faster. I have used the dogbone they give you but it will take you about 45 mins to pull each axle if they are bad enough.

its rust welded on man... the pass side axle bolt is garbage, cant come off, period, i took off the spindle with the axle on the pass side, driver side is another story, i broke lots of bolts,i have a buddy coming over with a torch... but i will be tearing down the motor tomorrow or sunday, i know what im doing except the timing...wanna stop buy sometime and kick it? if you free up that is

Save the spindles, dont let some hack heat it with a torch.....I will get them out myself.

You heat those with a torch and the bearings are garbage. Just dont touch them anymore. Drive them over to me on Saturday night if you can.

Terry

i got the engine out... stop by tomorrow if you want... if you wanna wrench, i wont stop you

Sunday night will work. after 630.