Hello,

I lowered my car with 1.3 eibock Pro spings. I still have camber probmes with this slight drop. I am going to purchase an ingalls kit with rubber bushings on ebay. It looks like those bolts that go though the A arms are had to get to. Could somone please give me an easy procedure to do this install. Or should i just have the alightment shop do it? They are going to be in there working on that stuff anyways.

Ryan Siefring
Located near Dayton OH, zip 45356
Student at the University of Dayton.

You have to get a shop to do it. You could do it but it wouldn't be as accurate as the computer.

1998 Eclipse GS

GS-T Axleback|CAI|OBX 4-1 Header|AF/X UDP|

you take the a arm off first with the 2 nuts accessible from under the hood near the shock tower. Then pop off the ball joint and remove the whole arm, then replace the bushings from there. then take it to get aligned

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Just "pop" it out hu? How is it done? I have never removed this before. Do i need any speical tools? HOw does it reinstall? Thanks

Ryan Siefring
Located near Dayton OH, zip 45356
Student at the University of Dayton.

Sorry for the confusion
Just undo the nut on the ball joint and pop the shaft out of the hole.
You will see, its easy. Just go do it

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

It won't hurt your car to drive from your house to the alignment shop after you do this, and it'll save you quite a bit of money in the end if you install it yourself. Go for it.

Representing the Central Cali chapter of 2GNT!
(I think I'm the only member )

Wow, that was easy! They are now installed. Thanks everyone for your help. Now it's time for an alignment.

Ryan Siefring
Located near Dayton OH, zip 45356
Student at the University of Dayton.