I'm trying not to unbolt stuff but it seems I can't take the swaybar out without removing most subframe stuff that's in the way.... any tips that can help? The car is raised on jackstands, I'm doing it at home.

1993 Eagle Talon TSI AWD: balance shafts, cruise & AC removed; 16psi, Dejon intake & UICP, ported 14b, EVOIII mani, ported 2G O2 housing, 2.5" Buschur dp to 3" Thermal exhaust, datalogger, front strut brace, prothane motor mounts

1995 Eclipse RS U-Boot; Tokico Illuminas, GSX front brakes, ST front swaybar, short shifter, CAI with K&N filter, rear disks and swaybar, front upper and rear lower strut braces, beater exterior

nobody ever installed an aftermarket swaybar?

1993 Eagle Talon TSI AWD: balance shafts, cruise & AC removed; 16psi, Dejon intake & UICP, ported 14b, EVOIII mani, ported 2G O2 housing, 2.5" Buschur dp to 3" Thermal exhaust, datalogger, front strut brace, prothane motor mounts

1995 Eclipse RS U-Boot; Tokico Illuminas, GSX front brakes, ST front swaybar, short shifter, CAI with K&N filter, rear disks and swaybar, front upper and rear lower strut braces, beater exterior

this page is the best i've seen
and yes you have to unbolt things
but at least here is the order of install


http://www.rernetworking.com/rmdsm/DIRECTIONS%202G%20Bars.pdf

1996 eclipse GS-T
1968 Ford Mustang
2004 Suzuki GSXR600
2006 Honda CBR1000RR
Decisions Decisions

thanks!!!

1993 Eagle Talon TSI AWD: balance shafts, cruise & AC removed; 16psi, Dejon intake & UICP, ported 14b, EVOIII mani, ported 2G O2 housing, 2.5" Buschur dp to 3" Thermal exhaust, datalogger, front strut brace, prothane motor mounts

1995 Eclipse RS U-Boot; Tokico Illuminas, GSX front brakes, ST front swaybar, short shifter, CAI with K&N filter, rear disks and swaybar, front upper and rear lower strut braces, beater exterior

When I did it I didn't unbolt anything. I ended up cutting one end of the stock sway bar so it was strait on the end and pulled it strait out. Getting the new one in wasn't too hard. Just a matter of finding the right angle to get it to slide into place.

well I followed the instructions and unbolted both "stays" and one of the compression control arms and it was easy to take the bar out and get the new one in this way.

1993 Eagle Talon TSI AWD: balance shafts, cruise & AC removed; 16psi, Dejon intake & UICP, ported 14b, EVOIII mani, ported 2G O2 housing, 2.5" Buschur dp to 3" Thermal exhaust, datalogger, front strut brace, prothane motor mounts

1995 Eclipse RS U-Boot; Tokico Illuminas, GSX front brakes, ST front swaybar, short shifter, CAI with K&N filter, rear disks and swaybar, front upper and rear lower strut braces, beater exterior