I was wondering if anyone has done this... Im puttin my stock springs back on and noticed they are quite a bit taller than the blues. I know on my factory struts they were about the same height and were easy to get on. Im goin to get a spring compressor today to finish raising my car up. I just need to know that they will work together.

This is probably a stupid question, but i figured id ask before i make the swap and have problems.

thanks

_______________________________________
The end of the internet begins here... www.broke-off.com

yes.... they will work together.

http://www.murderpimp.com





2gnt T-shirts&swag
http://www.cafepress.com/mads

not a bad combo IMO

-----------
'96 Eclipse GS
'94 Talon TSi AWD
www.SOVADSM.com

All gone now. Too bad, so sad.

that's what I have. it works well. i don't think it looks any higher, but it's hard to tell when stock height looks obscene to begin with. I love wheel gap. I love it. I do.

2gnt: '99 RS-T, killed by a toyota, pending rebuild...
Daily: Volt
Daily #2: '99 EVG ebike- STOLEN by PEDRO

I have the same setup, but just on the rear, haven't gotten around to putting the fronts on yet. I didn't need spring compressor to do it either.

~~~~~~~~~~~~~~~~~~~~~~~
'99 Eclipse GS-T
HRC Stage II
w/walboro 155lph, 30# injectors
Clarion AutoPC 310C
Avionixx
DEI Viper
IDQ12

i dunno about the rear but im definatly gonna need to use a spring compressor on the fronts. the springs about taller than the strut by about 2 inches uncompressed.

_______________________________________
The end of the internet begins here... www.broke-off.com