hmmm...i just got my rre lt bar. i'm sure i can pretty much figure out where to put it, but i've got one question. if there are two holes, then why did i only get one screw? and what's that cutoff piece of metal with the screw? if this is all i'm getting, then i guess these things connect to stuff already on the car, right? anyone put theirs on yet that can shed some light on it for me?
IM name = Chookeat (weekdays 8-5est)
97 ESi mods: pine air freshener (50hp in woods), new wiper blades (buahahaha!), afx udp, ractive stb, RRE lower tie bar, powerslot w/mm pads (f), PIAA superwhites, b'stone potenza re730's.
#1999, "where are those pics?" In response to Reply # 0
i might have missed it, but i just spent the last few minutes going through all the suspension archives etc. where are those pics that were posted that showed the install?
IM name = Chookeat (weekdays 8-5est)
97 ESi mods: pine air freshener (50hp in woods), new wiper blades (buahahaha!), afx udp, ractive stb, RRE lower tie bar, powerslot w/mm pads (f), PIAA superwhites, b'stone potenza re730's.
#2000, "RE: where are those pics?" In response to Reply # 1
You only got one bolt because there is already one that is on your car for where the lower tie bar will go. Its easy to figure out once you're under the car. Search for "RRE lower tie bar" in the General section for 3 months back, and it should bring you to my posts with the link to the pics.
I put mine on last night. The metal piece is a spacer and the bolt provided replaces the bolt on the passenger's side (where you'll put the spacer). You'll figure it out, it's a pretty easy install, especially if you have a hydraulic jack and jack stands. I took my front wheels off, so I'd have more more, but I was using the car jack and no jack stands.