Anyone know what the inner diameter of the hard brake line coming out of the proportioning valve leading to the front calipers is? I'll take inches, -AN size, whatever you got I can convert.

I... uh... had an incident with not using a flare nut wrench one of the lines leading to the rubber line to the caliper. So now I have to replace the line from the proportioning valve to the wheel well, before I can put my SS lines on the front.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

I'm almost positive they are 10 mm, I had to replace one a while back.

Joel Baldridge, ASE Certified Master Technician, Audi Certified Expert Technician

I know the fitting n the end is a 10mm fitting, but I'm actually curious about inner diameter of teh tube.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

not sure but a part #for FR brake line to the pv is mb895894 give mitsu a call and ask em.

Dan at allmitsubishi.com might have one in the salvage yard on one of the cars. There is not much call for those lines and as long as there is not a MASSIVE front end collision, you might be in luck. He ships UPS.

If for some reason, he has one and cannot get it right out, PM or e-mail me Michael and I will go pick it up and send it out to you ASAP.

97 RS(PTE SC-61, Built Long Block, Electromotive Tec 3)It's Here!

Ahh very good idea sir. I'll try to give him a call this afternoon and see what he's got. Thanks! and thanks for the offer to pick it up.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC