im getting this bar, but will i need to get anything alligned after i put it in, what do those bolts connect to, its kinda dark out. or can i just take the bolts off, and put it on w/ no worries, what are the torque specs for it? later chris
#13475, "RE: neuspeed bar question" In response to Reply # 0
no alignment, nothin special.. if u have cruise control, prepare to push into it a lil, or drop it down an inch or two... u will need to space the brake fluid resevoir a lil out, so the bar fits behind it...
i think the bolts are 17mm, may be 21mm, i dunno off the top of my head...
use the bolts that are close to the strut tower, but closer to the firewall... it takes a lil work to line up the holes on the bar, but u will get it in no time...
shouldnt be more than 10 min install... i think the torque spec is 75 ft. lbs.. just make it tight....
payce
03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003) now: 20g, portfueler, bpu+++ (track/dyno times tbd...) i farted on your wiki
Search
Printer-friendly copy
0 Users in Chat
