#4468, "Trying to get tach to work." Apr-19-09 08:13 PM by 1slw97
I can't figure out how to get the stock tach to work. I have the tach out wire from Megas... To the factory tach wire ( Solid white) wire. I also turned the tach out, in megatune on. any ideas?
#4469, "RE: Trying to get tach to work." In response to Reply # 0
I'm assuming you built the tach output circuit? Make sure you have the tach output configured right in megatune for how it is wired (ex: circuit connected to js3 on pcb 3.0, tach out js3 in megatune).
#4475, "RE: Trying to get tach to work." In response to Reply # 1
Originally posted by Jungy I'm assuming you built the tach output circuit? Make sure you have the tach output configured right in megatune for how it is wired (ex: circuit connected to js3 on pcb 3.0, tach out js3 in megatune).
I did not build the Tach output. This is a Symtech unit. It was set to js3 in Megatune.
#4476, "RE: Trying to get tach to work." In response to Reply # 0
Originally posted by 1slw97 I can't figure out how to get the stock tach to work. I have the tach out wire from Megas... To the factory tach wire ( Solid white) wire. I also turned the tach out, in megatune on. any ideas?
Is the white tach wire still connected to the stock ECU?
#4478, "RE: Trying to get tach to work." In response to Reply # 4
Dash us off an email at support@symtechlabs.com so we can discuss the particulars of your order. The tachometer output wouldn't be installed on JS3 if your Megasquirt ECU uses a MS-II processor.