anyone have any tips on installing a fp gauge i got a summit one so it is just the gauge and i'm not exactly sure where to place it btw i have the later fuel system with fpr in the back
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#91110, "RE: FP Gauge install?" In response to Reply # 0
I guess you could just tap it in to your Schrader valve. Youll have to pull the pin out first. Either that or you have to find a way to do it at the feed line. I dunno what else to tell you. I hooked mine up after I ran a return line.
#91118, "RE: FP Gauge install?" In response to Reply # 1
not to be super super picky...but i dont want someone to read this and get the wrong info. the place that youd tap into would be your TEST PORT. the "schrader valve" is the little peice inside it....like the one in your tires valve stems. those are the actual schrader valves, not the port. but yes, you would need to remove the valve with a special tool (called a schrader valve puller/remover) and then fit your lines for your FPG.
#91121, "RE: FP Gauge install?" In response to Reply # 4
I would imagine that you could use a "core tool" from a tire shop/etc aswell. Those are the exact same cores that are found in valve stems (go figure). Anyways, it is basically a metal rod with a slit in the middle to fit around both sides of the core.
Search
Printer-friendly copy
2 Users in Chat
