ok i bought a 98 rs 420 with a spun bearing so the motor is all apart i want to know how i should build for around 15 psi what piston cams exc the more info the better
i'm not trying to be a dick but asking questions like this will get you OWNED around here bro. every person that replies to this thread will tell you exactly the same thing...search. this site contains all the info you need but you have to go find it yourself. good luck...chris
My friend, we have 5+ years of info stored on this sight in 10's of thousnds of posts. You simply cannot come on here and ask us what you should do. we will not help you in that regard, you need to search and LEARN for yourself. if you get stuck on something then thats a different story, but to just ask a generic "what do i need" post wil ge tyou flamed. If we wanted to build cars for other people we would open up a shop and make money!!!!
Search and learn!
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
i did search after every thing i read i can find any thing about the top end i lower i going to do with 8:8:1 forged piston get the block 20 over all bearing exc what about for cams i cant find any thing on them
check 'Advanced Tuning' section, or the 'Turbo/Nitrous' section. Plenty of info there. But as far as a quick answer, lots of people have said that the stock cams are good for a turbo in low-boost, Crower twos seem to be good for mid boost range (7-12), and higher boost levels like Crower 3's or the similiar Cranes (I forget which). Top-end is PT lifters and lash adjusters, aftermarket srings (stiffer), 1mm or 2mm oversized STAINLESS STEEL valves, port and polish it, I don't think there's too much secret to it.
Representing the Central Cali chapter of 2GNT! (I think I'm the only member )
Originally posted by Keith2172 and higher boost levels like Crower 3's or the similiar Cranes (I forget which).
No. There is far too much overlap in those cams for a boosted application. Not all aftermarket camsd play well with a turbo application, whereas the stock cams always play nice. For the money, the stock cams will get you very, very far.
______________________________ If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.
'95 Eclipse TurboGS (garage deco) '95 TSi AWD (restoring a survivor) '97 Talon ESi-T (poor impulse control) '99 Eclipse RS-T (daily beater) '13 Evo X (mostly stock) '17 Sienna (Middle Aged Dad Mobile)
Originally posted by mschwabrs i did search after every thing i read i can find any thing about the top end i lower i going to do with 8:8:1 forged piston get the block 20 over all bearing exc what about for cams i cant find any thing on them
Holy shit dude! try some goddamn punctuation and proof reading before you hit the enter key.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
you're right, i was new once. But i was new WITH PUNCTUATION and CORRECT GRAMMER!!!!!!!!!!!! try it out for size...
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
Search
Printer-friendly copy
2 Users in Chat
)
