So, I will be completing the wiring tomorrow. I bought it off ebay so no paperwork, etc. My question is, I plan on mounting it using the bracket that it came with, I just can't figure out which end of the bracket goes on the back of the unit. The one with a single bar or double? I plan on inseting it above the HVAC in standard fashion. Any one got some pics? Thanks.

Second Place "Sanford Sound SLAP 2005" Mild 2-Door
http://www.sanfordsound.com/carwash2005.htm
Second Place "Scrapefest 2002" 2nd Gen Mild
1995 GS AT, 97-99 Conversion.
2000 BMW Z3 2.8
1999 Chevy K2500 crew cab
5 jets skis, 3 snowmobiles, 2 ATVs. BRAAP!
Member # 1147

if i recal, the side that says apex-i is the back, not 100% sure tho

-MIKE-

Stroked 2.2L

From RRE:


We used the bracket supplied by Apex and slid it into the crevice just below the A/C vent. By bending the bracket just a touch, it was able to grip well. The bracket will allow for mounting on just about any surface with either screws or double sided tape.

BRILLIANT! Thanks

Second Place "Sanford Sound SLAP 2005" Mild 2-Door
http://www.sanfordsound.com/carwash2005.htm
Second Place "Scrapefest 2002" 2nd Gen Mild
1995 GS AT, 97-99 Conversion.
2000 BMW Z3 2.8
1999 Chevy K2500 crew cab
5 jets skis, 3 snowmobiles, 2 ATVs. BRAAP!
Member # 1147

geres how i mounted mine looks much cleaner i think very easy to do as well. You just need to have an aftermarket radio, and just cut the black trim panel that goes around the hvac and radio at the bottom inbetween the 2 grab points.
http://aseclub.net/phpBB2/viewtopic.php?t=49280

-MIKE-

Stroked 2.2L

Its a lot further away from the shifter then it looks, you would have to have your hand come flying off the shifter to hit it. It doesnt even come close to rubbing.

I have seen several cars that have them in the show off postion and then get broken into. After you tune your car you don't even need to watch it, just put in your center console or glovebox.

_____________________________________
Scott
90' GSX, 06' Effo SSL

(parting out 95 GS)