I have a 97 Dodge avenger, 2.0 420a motor. I have a t3 all bolted up and ready to go, just have to figure out my fuel setup and wastegate. I Have 450cc injectors dsm which should plug right in to my stock harness and rail, but do i need to get a different pump to keep up with them or will the stock one be sufficient? Im going to be running 6-7 psi, no more than that. Also, can you run a wastegate off of just one runner on the header and have sufficient boost control? To take care of the map sensor im using a 1 way check valve between the map sensor and the intake manifold, so it will not detect any boost. Any help at all here would be much appreciated.

wrong section...

1992 Plymouth Laser
-Bone stock for now.

.

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)