#73917, "***wideband graphs for my Dyno runs inside*** motor Einsteins, get in here...(56K no good)" May-02-04 02:39 PM by tim97rs
okay, heres the dyno sheet.
and here are the wideband read outs from my LM-1. Unfortunatly, i cant get them to precicly coinside with the corasponding dyno run, and im not sure which run is for which dyno read out. however they are similar enough to get the idea, and to help me figure out my bouncy-bouncy boost issue at high boost.
wideband reading #1: i think this was my first run at 9psi.
wideband reading #2: this should be the run i did at 17.2 psi.
wideband reading #3: this one should be after i dialed my boost controller in a bit better, at 16 psi, i think...!
okay, so what do you guys think?
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#73940, "RE: ***wideband graphs for my Dyno runs inside*** motor Einsteins, get in here...(56K no good)" In response to Reply # 3
Originally posted by WheatKing hummn.. next time make sure the idiots running the dyno use atleast 6 straps to hold it down to the rollers.. looks like your tires were sliding on the rollers.. -- WheatKing
that did happen on one run pretty bad, had to stop the run. this was done on a portable dyno, TnT dyno. i seem to remember a little side to side on the others to, but....??????
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
Search
Printer-friendly copy
1 User in Chat
