I know this is a very easy question. But, to change your setting you just loosen the screws and adjust it by hand when the car is off, right? Just want to make sure, I don't want to mess anything up. Sorry for the dumb question.

Thanks

as opposed to loosening the bolts when the motor is running and then turning it by hand?
sorry, im drunk!

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)

No, i'm not that dumb, I was just making sure that you didn't have to do anything else.

make sure you torque the bolts down CORRECTLY, or they may slip! other than that, its pretty straight forward. good luck.
tim

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)