well, my problem is i have the DSM disc, feeler gauges and all the clearance specs (according to the DSM disc), but im not sure what exactly im im supposed to be checking and where.
I have the crank in with the crank bearings and the bedplate assemb. to the block. oil and H2o pump in place as well. thats where im at so far. what clearances should i check/have checked up to this point?

im getting help with the rings, but i have the rods and pistons put together.

okay, lemme have it.
thanks guys
tim

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)