im trying to find the oil sending unit so i can install the sending unit that came with my oil press. guage. there is a part that goes into the back of the block that has a wire running out of it right above the oil filter if you are under the car looking up. what in the hell is that? and where can i find the sending unit? thanks
i did a search, found the writeup, but it doesnt say where the sending unit is...
#61561, "RE: what the hell am i looking at?" In response to Reply # 0
look to the left and up a tad of that sender. thats where you'll see your oil seniding unit. tim you need a 1 1/16th sending gauge socket to get it out.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#61564, "RE: what the hell am i looking at?" In response to Reply # 2
It'll look like a harness connector, some wire, and a sensor screwed into the block. If you can get under there far enough, it isn't too bad. I can reach it from the top, but then again, I don't have too much under my hood anymore, other then the bare necessities. -=B-=
Dude, Boeing called. They want their wing back.
Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate. Me: Can I put that in my sig? Dark0ne95: GO right fucking ahead.
#61569, "RE: what the hell am i looking at?" In response to Reply # 3
the harness that plugs into the oil sending unit(if its like mine, a 97 model) should be a neon green color. i HATE the oil sending unit. better have a big wrench. 1999 Black C5 1997 Silver RS Wiseco 8.8:1 Pistons(back to low compression!) Eagle Rods T3/T4 Turbo Custom FMIC Greddy Exhaust 390's Most current 1/8th mile time: 8.3@90mph 2.015 60'(Nitto Drag radials, i suck)
#61573, "RE: what the hell am i looking at?" In response to Reply # 4
mine looked idetical to the one your refering to, (which is the knock sensor I believe) but like ^^^ said it's closer to the drivers side and a little higher up. It's not that bad to get out...I was able to get in there with a 1/2 drive socket wrench. The harness is a little tricky to figure out at first, you have to slide the red tab one way or the other and then press on the green tab and pull. Hope that help
Search
Printer-friendly copy
1 User in Chat
