Well ive got the engine pulled from the car while im replacing the stuff from where i spun that bearing. What else should i do while the motor is out to increase performance? Any suggestions?

96 Eclipse Base 5 spd
Rebuilt engine w/ forged internals, APC Air Filter, Clear bumper lenses, 15" ICW wheels, Alpine v12 amp, 2 12" Xplodes, 5.6" lcd monitor, Dvd player, Playstation 2, Power1 Exhaust, Aerospeed Wing, Altezza tails w/ painted center, 20% tint, Silver Graphics, Audiovox alarm system.

Big transformation underway this winter!

I wish I would have done my clutch while my engine was out

do0d! Defintitely try to pick up a clutch and new throwout bearing. I got a PT Cruiser clutch from Bob Kise and then snagged a bearing from the local Satan for about $41 incl tax.

If you've got it out, you might look into getting a rebuild kit from Motofool. I would assume you don't want to pull it again for a while, right?

New headgasket? port&polish your TB & mani?

I say clean up your engine bay.....there is nothing prettier then a very well organized engine bay




Performance: Stuff that makes my car run better or go faster

Looks: Stock because looks doesnt make my car go faster or run better

Weight Reduction: CF Hood, No A/C or Powersteering Accessories, No rear interior

^^That's my suggestion too. Grab a can of degreaser, a few rags, and some new wire looming and have a blast while you have room to work in there!

You are not your job.
You're not how much money you have in the bank.
You're not the car you drive.
You're not the contents of your wallet.
You're not your fu**ing post count.

97 Eclipse GS - *SOLD*
01 Audi A6 2.7T
01 YZF-R6