Hey guys/gals.
Hey I know i posted this message in the General section but I need help bad!! Ok here we go. I have changed my ball joints, halfshafts, tie rods (inner and outer), and I still get a strang clicking noise. It sounds like when a CV joint goes bad but I bought strong new ones and also I have changed everything else. It clicks/pops when ever I come to a slow down, turn hard and any direction, and now accelerate. I am getting really PO'd and I dont want to spend any more money than I have to. ANY HELP is appreciated.
DJTJ

Single click or steady repetitive click? Could be a bad motor mount as the engine transfers weight. Maybe check the condition of your suspension bushings too...



15.9 @ 86.7mph

Una Salus Victus.

Mods List:
http://highlander.dsmpower.com/sig.htm

It only does it like once or twice in each circumstance. Yes I thought it was my engine mounts as well so i checked the transmission one didnt look bad but i changed that one, and then i got the inserts for the other 2 (not the passenger side one). It still does the clicking. Do you seriously think it is those other bushings even though it only happens at those specific times.
Thanks,
DJTJ

I replied to this post in General, but I'll reply here too. It might be a bad wheel bearing.

You are not your job.
You're not how much money you have in the bank.
You're not the car you drive.
You're not the contents of your wallet.
You're not your fu**ing post count.

97 Eclipse GS - *SOLD*
01 Audi A6 2.7T
01 YZF-R6