is this too big for our cars. I found a jeep big bore 62mm throttle body on ebay and i just want to make sure before i purchase it.

too big IMO

2gnt: '99 RS-T, killed by a toyota, pending rebuild...
Daily: Volt
Daily #2: '99 EVG ebike- STOLEN by PEDRO

what are your eventual plans for the car? 62mm sounds nice, but i dont think u can match the opening on the intake manifold to that. i'd do it just to say i had it. goodluck.

well i dont see no difference 60mm is to big too why not go 2 more mm wont hurt it.

ill be usgin a mustang 65mm throttle body on my 2.4 turbo but then again i have a whole lot of work into this motor and turbo system...

Bill

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

Dang, motofool I wish you lived near AL. I would kill to ride in that beast. Goodluck.

if your using stock intake, 62mm is over kill. you wont get any benefit from it. you have to port out a lot of the intake opening just to get 60mm, and i had to have aluminum weld placed so i could have a true 60mm opeing.

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)