Welcome to the 2GNT Forum!
Home Site Background Info & Specs Mods & Tech Info CAPS Part Reviews Donate 2GNT Stickers
Search Printer-friendly copy 0 Users in Chat
Top 2GNT Technical Performance/Engine topic #53648
View in linear mode

Subject: "cel on and heater won't work...help me out please" Previous topic | Next topic
scottfreeman80Jun-22-03 01:35 PM
Member since Nov 13th 2002
88 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#53648, "cel on and heater won't work...help me out please"


          

so i was driving home friday night nice and normal, not trying to race or drive hard. Temp. gauge was normal and all of a sudden the CEL came on. I then tried to put my defroster on and no hot air came out, only cold, so i tried the front vents and floor, no hot air at all. When i got home i tried to get a code from the engine. nothing happening, CEL turns off and doesn't come back on until car is actually running. Checked plugs, all radiator components, electrical connections, battery, all belts are o.k., only other thing i found wrong was that the car idles a little lumpier than it did before, but it always had a pretty lumpy idle. Dunno what to do next, any thoughts or suggestions? I would appreciate the help. thanks -Scott

1995 GST
6-bolt JDM swap
Evo 16G port/polish
28x7.5x3.5 FMIC (had to cut bumper to make it fit)
686 Injectors
Walbro 255-HP
ACT 2600 Clutch
Full 3" Turbo-Back Exhaust
RamCharge MAF Translator w/ upgrade chip
RRE Front/Rear Strut Bar
Eibach Pro-Kit
NGK Plugs/Wires
Crushed 1g BOV vented to atmosphere
Apexi SAFC
Powerslot Rotors
Autometer Phantom A/F, Boost, EGT
Redline Synthetic M.T.F.
2g Manifold ported w/ ported 02 housing
K&N Custom Cold Air Intake
Apexi Turbo Timer
Joe P MBC @ 19p.s.i.

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Replies to this topic

420AYEJun-22-03 01:47 PM
Donating 2GNT member
2850 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#53650, "RE: cel on and heater won't work...help me out please"
In response to Reply # 0


          

i had that same no hot air prob. but my temp gauge was slammed to the top. dunno. i just filled my radiator with water.... i was really low. try flushing out your radiator. you need to do it more than once cuz it takes a few times to get all the gunk out. then fill it with water and antifreeze. pull the radiator cap off your car and start it up. after a while when the car gets warm, it will open the thermostat right where the cap was. if it is working, you'll be able to see it flowing water through there.. if it doesn't come on and your temp gauge goes up, your thermostat is bad... but if that never happens i dunno.

Having Problems? Heres my Three step solution to anything 2gnt related.
Step 1: Put down everything in your hands.
Step 2: Grab a lucky strike, Smoke it.
Step 3: Walk to the fridge, double fist some keystone ice, sit down in the shade, drink one beer, finish cigarette, drink other beer, roll a joint, smoke it, walk back to your problem, and in about 5 minutes the solution will come to you.
If not. Go here: here

If still nothing, your trying to hard. Start over at step 1.

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Top 2GNT Technical Performance/Engine topic #53648 Previous topic | Next topic
Powered by DCForum+ Version 2.2
Copyright 1997-2005 DCScripts.com, Copyright 2005-2026 2gnt.com
Generated in 0.066 seconds, executing 16 queries.