anyone whos got this, or any relocation kits, do you have pics of your install?

mine came today, just curious how everyone else did theirs

95 Avenger
ATX->MTX Swap
Holset HX40 @ 26 psi

yea me too i already ordered mine and it should be hear in a couple of days. Just wondering where people placed the batterys and such

i just bought on from jegs...its the same kit...the only problem w/ this is that you'll have to buy a kill switch to be able to run at the track...i'm not sure if i want to do this or not..would be nice for the extra room under the hood though

400whp or bust.

You will need a cutoff switch, a metal box (The Summit kit is plastic, which is NOT NHRA legal), and a vent tube that goes to the exterior of the car (even if you have a gel battery that doesn't outgas...). So many rules and regulations...
-=B-=

Dude, Boeing called. They want their wing back.

Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate.
Me: Can I put that in my sig?
Dark0ne95: GO right fucking ahead.

funny ... no one has given me crap about it at the track. Hides in the spare tire well and I never mention it so they never look. Hell I don't even keep the lid on it. Just the cover for the spare tire well (which is 1/4" wood now not the crap material it was before)

-"Easy Mac"
05 Mazda RX-8 (RR8 #88)
99 Eclipse RS 398whp & 372lb-ft

My local track would give me grief to no end, so I need to find an NHRA-legal kit.
-=B-=

Dude, Boeing called. They want their wing back.

Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate.
Me: Can I put that in my sig?
Dark0ne95: GO right fucking ahead.

Bill do you know anybody that does welding?

Go to the hardware store buy yourself some sheet steel, cut to the dimensions you want have the bottom and sides welded together, get a couple hinges a rubber seal for the top and a latch, make a battery tie doen wiith some stock threaded rod and some scrap left over from steel. then drill three hole: pos, neg, and vent. A few grommets run the wires/tube and you should be set.

That or find one that's pre-made



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

Fuck a box!


I ordered the Summit kit and all I used were the mounting bracket and cables. The box is to big, unless you rip out all the shit in there. In fact, I think I need to do that.

"Natty Ride"


http://dirty.thisfreedumb.com/