ok i broke the pully bolt off in the engine. should i just drill a hole through it and use an easy-out on it or is there a better way?

did you snap off the head, of break the actual bolt. if you just broke the head off and have some bolt stickin out of the engine, see if you cant grab that with something and wrench it out.

-----------------------------------------
2011 Nissan Xterra Pro-4x

2007 Kawasaki Ninja 650R

1996 Mitsubishi Eclipse RS-NX 75 shot, AEM CAI, P&P t/b and intake mani-SOLD

1964 Buick Electra 225-all original, all power options, 325hp, 445ft/lbs tq

before you do anything, get the broken piece of bolt, and stick it back in the crank, and try and twist out the broken part of the bolt by hand. Hopefully, if the crank threads were nice and clean, you should be able to do this.

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)

umm.. did you break the bolt while loosening or tightening the bolt? if it happened while loosening... then none of their suggestions are going to work and you'll have to try the easy out.. but i doubt it'd work.. if it happened while tightening.. shouldn't be hard at all to get out,unless you cross threaded it.. then your really screwed.