I Bought A built head to for ever to get and it is missing the cam caps/bosses what ever you want to call them can i use some from another head. Or do i need the ons for the head. I no there bored when there put on the head as a one shot deal. Are they all the same on all the heads or will they very. Thanks

They should all be the same, I would check alignment of course. But you should be fine, and put them over in the same spot they came off of, they are numbered.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

What do you mean by that they were bored? If the bearing halves in the head were just cleaned up, then you can use or buy all new cap bearings. Like michael said, they are numbered,and have arrows on them to designate the "front" of the engine, which is the timing belt side.

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)