I am planning on getting a Bomex rear bumper which has a exhuast cut out on both sides of the bumper. I was wondering if it is possible to put dual exhuast on my car. If so where can i pick up a good system, or do i have to get custom piping? Or should i just stick to exhaust coming out one side and leave the other side alone? What exhaust does everyone recomend?? I wanted to get greddy EVO with 3 inch piping. If ya could help me with this that would be great!

Greg

are you going for preformance or looks. Are you going turo/ already turbo cause first off 3" exhaust is too big for a N/A car. If you want to go dual go 2.5 or 2.25" setup, you will lose back pressure if u use a 3". As for preformance gains in a dual setup, none, more likely to lose power.

Since our cars are inline 4's we dont take well for a dual setup.

Also if you still wanna do a set up, you would have to get some kind of Y splitter to create the dual effect, yea i would say im 80% sure that you would need a custom piping done. Iv only seen duals made for a gsx.

there is no dual exhaust made for our cars. if you want that setup it has to be custom made. a couple people here have had it done.

- Dan

HRC Stage 2|30lb injectors|S-FMU|Walbro255HP|AFX UDP|B&M Short Shifter w/ Symborski Shift Kit|Rear Strut Bar|Power Slot Rotors|more...

I am going to get a turbo kit pretty soon. I was told to get 3 inch exhuast, take the loss or awhile and when i get a turbo it will be much better. Is that wrong, should i go smaller, even with a turbo system?

Greg

for turbo if you're boosting a lot..i'd say get a bigger exhaust..catback 3" exhaust..not a non-turbo one..it limits the air flow too much. Also ask dualgen2 about dual exhaust..he has one..it's quite nice

Mark

'95 Eclipse GST - gone
'00 Jetta GLS