how did you mount it? there are only 2 screws coming out of the side of it. also, the inlet is like a -6an fitting, not one of those ridged tappered fittings.

- Dan

HRC Stage 2|30lb injectors|S-FMU|Walbro255HP|AFX UDP|B&M Short Shifter w/ Symborski Shift Kit|Rear Strut Bar|Power Slot Rotors|more...

Mine is in my sig.
More pics at www.geocities.com/agent_oi

"Natty Ride"


http://dirty.thisfreedumb.com/

If you look between my intake pipe and the upper intercooler pipe, you'll see the filter for my catch can. I just zip-tied it to the water pipe that runs next to the block. It's not actually a Summit catch can though, so mine did have hose barbs as inlets so the hoses weren't a problem to attach.

You are not your job.
You're not how much money you have in the bank.
You're not the car you drive.
You're not the contents of your wallet.
You're not your fu**ing post count.

97 Eclipse GS - *SOLD*
01 Audi A6 2.7T
01 YZF-R6

^^^What did you use to cover the A/C hoses in the bottom left hand corner? Looks pretty tight.

So if I add a catch can, what do I put in the opening in my AEM intake?

Allan
2008 Magnetic Black 350z NISMO /1976 Austin Mini 1098 Special (export)

Member# 1980

The A/C hoses are covered with red wire looming, as well as all the stock wiring. It was easy to redo with the engine out.

I went to a local auto parts store and bought a patch kit to cover the hole in my air filter.

You are not your job.
You're not how much money you have in the bank.
You're not the car you drive.
You're not the contents of your wallet.
You're not your fu**ing post count.

97 Eclipse GS - *SOLD*
01 Audi A6 2.7T
01 YZF-R6

Dirty, what fitting did you use to attach the lines to it?

- Dan

HRC Stage 2|30lb injectors|S-FMU|Walbro255HP|AFX UDP|B&M Short Shifter w/ Symborski Shift Kit|Rear Strut Bar|Power Slot Rotors|more...