Got a problem I been driving lately and as soon as my car gets warmed up my idle starts to drop all the way down to 0, and wont come back unless I give it some gas. Sometimes the car evens shuts downin mid RPM. I put the vaccum gauge on and the needle was flikering beetween 0 and 5 saying vaccum or timeing. I eliminated the EGR system. but can't find the (vsc or vcs)persure line, But I have all the stems caped off. Not sure about the plate over the EGR inlet behind the throtle body.I also have new Crower cams that I have been gearing in. Mitsubishi say that its my Idle Seed servo and it can sometime cause my ecu to bad, and that I might need a new servo and ecu. need some input.

Is your check engine light on? What do you mean by "sometimes it dies down mid RPM"? Does that mean it dies even if you have your foot on the gas pedal? Or does it mean that it dies when you let go of the gas pedal from mid RPM?

If the car is dying with your foot off the gas - yeah it could be the IAC(Idle Air Controller) motor. If you have a buddy with an eclipse, you should try swapping in a known good IAC before buying one. They usually trigger a CEL when they crap out.

If it's dying when you've got your foot on the gas pedal then its probably not the IAC.


ride__________95 Eclipse RS : 5 speed
power________Gude cams : Jeep TB : AFX UDP : ram air : test pipe : GST catback
suspention___BOMZ F/R upper strut bars : ES inserts
sound________Kenwood KDC 5000 : Audiovox 8" sub toob - no sub amp(damnit!)
shizzle_______AutoCommand remote start : dual air horns : Caspers o2 simulator(rear)
incomming___Hurricane F/R lower strut ties : Field SFC Hyper-R
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html

95 Eclipse RS : 5 speed
14.76 @ 94.72mph
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html

It hit zero when I take my foot off, but occasionaly die out with foot on the pedle. Its more like a total electrical shut down.Then I tap on the ecu and here somthing on the throttke body click on. the the Idle problems start. Rcently it just been a idle problem.(2days)

Check for vaccum leaks, the EGR system uses vaccum sources off of the back of the intake manifold. also, check your IAC also, that could cause idle problems. it also could be something as simple as a loose fuse or ground. do you get a CEL?



www.TeamKLR.com
1997 Silver RS
12.3@118mph,20psi, race gas(drag radials)
Wiseco 10.5 Pistons
Eagle Rods
Started as a manufactured turbo kit, now its a custom one!
Vortech FMU
Greddy Exhaust
440cc Injectors

Waiting on the EVOlution!

1997 Silver RS
Built
T3/T4 BB Turbo
20psi
Most current 1/8th mile time: 8.1@93mph 2.015 60'
1996 Black Supra TT
2004 Silver Snake

What year is your car? if it's 95-97, you can do the "keydance" to check the ECU's diagnostic trouble codes. If you're 98-99, you can use an OBD2 scanner/datalogger or go to Autozone t have your codes checked. Find out what codes your ECU is throwing, and it will better help us to diagnose your problem.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

Definetely check your MAP sensor, I had those same symptoms when mine took a dump.

The last time I put the OBD2 on the codes I got were EGR circut malfuncion and secondary air injection valve circut malfuncion. ever since then my cel has been on, but I haven't checked it since this started. where is my map located

It's the sensor on the top passenger side of the intake plenium.

I just put a new block off plate on the back of the intake (EGR). I was talking to some of my mechanic buddies and they said it could be because I haven't degreed my cams in, and its runing a little retarded. but that dosen't exsplain my car shuting down.I'll check that map sensor. does any one know how much a IAC cost. hopefully I don't beed a new computer. If I do where can I get a good one and how much should I ecpect.

Let the ECU get used to the cams.

IAC could be bad etc. But give it a little time and let the ECU adjust. My ECU was confused when I first installed them, I played around with a lot of setting on my S-AFC when I installed my cams. I'm back to 0 correction at idle. But I also am pretty sure my head gasket is blown, so needs a little work there too.

Una salus victus.
He will triumph, who knows when to fight, and when not to fight. - Sun Tzu

Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

All motor in the making.

Injen CAI, P&P Intake Manifold, Crower Stage 2 Cams, Hooker Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, Crane Fireball HI-6DI2, FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730, Front KVR Cross-Drilled Rotors & Carbon Fiber Pads

To Be Installed: P&P Milled Head, Rear Disc Brakes, Rear KVR Cross Drilled Rotors & Carbon Fiber Kevlar Pads, SS Brake Lines, AFX 55mm TB (re-installed once exhaust is done, intake was outflowing exhaust)

Firefly:
Mal: You don't know me, son, so let me put this to you plainly: If I ever kill you, you'll be awake. You'll be facing me. And you'll be armed.

Don't agressive cams kill your Idle vacuum pressure?
From what I know of most cars with GOOD cams, they have a problem with Idle. isn't that just the status quo?

peace
WIKKI


THAT is not f**king THAT!
THIS is f**king THIS!

mine kindof does the same thing cept when i let the car sit for too long, it'll go to die and then when i get the rpms up, it runs really bad almost like i just lost a compression in a cylinder. was thinking it might be a fuel injector, or my coil. my check engine light kept coming on but when i turned my car off and then started it back up, the light was off. i think my problem is the same as his but not sure.