Where des this go? How hard is it to do a self-install? Is it a power steering, crank or what kind of pulley replacement?

This is a must have mod.......fairly cheap and good HP...The afx crank pulley is better looking also weighs less than the stock pulley. It is a replacement for the crank pulley which turns the Accessories like ac and power steering..it also turns the alt. Install is fairly simple......just lower the engine support it slapp on a 3 ton gear puller and take it off........Draw on the new pulley or heat it up to appox 500 degrees and slide it on. make sure you tighten the new belts with the correct tention or it will squeak like all Hell and you will hate your car

So, I would use acherry picker or something to hold my engine?

no just remove the passenger side motor mount. and use a floor jack with a nice piece of board under the oil pan and use the jack to take the weight off of the mount

Yeah use a floor jack and board..cherrypickers are so...so HONDA.....hehehe





-AF/X underdrive crank pulley
-AEM Cold Air intake w/bypass valve
-PIAA headlight and foglight bulbs
-Clear bumper lenses
-Eibach Pro-Kits with Tokico n/a shocks
-Pilot Motorsports Front upper, Rear upper, Rear lower strut bars
-PowerSlot rotors (all four)
-Axxis Metal Master pads
-RRE rear camber kit
-Dunlop SP SPORT 8000 tires
-ECLIPSE word on dash
-Red Mitsu symbol on steering wheel
-Painted fog light bezels
-Window tint
-Magnecore wires and NGK plugs
-Purple interior lights
-Purple hose kit