every time when I turn the steering wheels all the way to the left or when I turn the AC on, I heard a loud squeeking noise, I know it is one of the belts, which one is that? can I tighten it by myself or I better get a shop to do it for me?

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayama projectors headlight/K2 8000K HID system /WW 3 pieces wing/interior mods

Ken


5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(fron

Could be your power steering pulley bearings. When my bearings where shot, it would make a squeeky sound when I turn the wheel. Do this, look at your power steering pulley, then have someone crank and start the car. If the pulley shakes, then chances are, it's your bearings. That's what mine did. Good luck!!!!

Kris
"Someday............I'll have traction problems!!!!"
Tampa, FL
Pinoy Turbo 2GNT

1999 HRC Turbo RS
Stage 2
Auto with BOOST!!!!!!!!!!!!

ahh,,,which one it is? Thx

Ken

5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(front)/shunk2 coilover/Koni adjustable (front)/KYB struts(rear)Konig V-racing front bar/rear upper bar/painted black Enkei RSF2 17" with Kumho/ Nakayama projectors headlight/K2 8000K HID system /WW 3 pieces wing/interior mods

Ken


5zigen rearsection/Cherrybomb glasspack resonator/Bosal header/injen short ram intake/ported TB/AFX UDP/Fidanza cam gears/Power Stop cross drill rotors(fron

The power steering pulley is the one right on top in the front of the engine. It is directly above the PS Tensioner.

On a side note, I also have a similar problem except I get a squeal only at 2800rpm when I am accelerating/decelerating slowly. It only does it when it's moving(in any gear), not in gear with the clutch in. Anyone got any ideas? And BTW, both of my belts were just changed along with the tensioner, but it did it before the new belts.

-Nate



________________
-98 Avenger I4 5spd
-ALL MOTOR build up on the way
-Mods: AEM blue front Big Brake Kit, AEM blue CAI, Bosal Header

Next Mods:
Bored Throttle Body, Ported Intake Manifold, UDP

-Nate

___________
-88 Mercury Tracer 1.6 3spd auto
-95 Eclipse GS 5spd
-Mods: Megan Header, Megan Cat-Back, Pacesetter High-Flow Cat, AEM V2, Fluidyne Radiator, Hurst Short Shifter, Prothane Motor Mounts
-All-Motor Buildup on the way
-VIS Invader hood, R34 front, Halo Proejctors, M3 LED Mirrors, Projector Fogs, Blue Heater Hoses

my car made that noise when i turned the wheel all the way too when i first got it. i took it to a mechanic and my power steering belt was loose and they tightened it and it didn't make that noise for about a week then it started again and turned out i needed a new power steering belt all together.you might wanna check your power steering fluid too just in case

1997 Mitsubishi Eclipse GSX: K&N Filter, John Sheppard built transmission with GVR4 1st gear, autometer boost gauge, "free mods", Greddy type-s BOV, broken shifter