was wondering if anyone had a couple i could use, if not cool, i just didnt know if someone had some layin around extra or something like that.


96 Talon ESi Mods
apex' dunk exhaust
injen short ram
magnecore 8.5mm wires
front/rear strut tower bars
custom painted interior
carbon fiber hood

I contributed to the Wiki.

dino hookd me up awhile back for 5bux shipped......

b4 then, i just cut up a coke can to fit, and used sum high temp gasket maker....

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki

well, i found some sheet metal at my house and im fabricating some gaskets to fit so I think I'm set. By the way I got some gasket maker its this red silicon shit i dono exactly what it is, it said high temp up to 650F. So I hope this shit works.


96 Talon ESi Mods
apex' dunk exhaust
injen short ram
magnecore 8.5mm wires
front/rear strut tower bars
custom painted interior
carbon fiber hood

I contributed to the Wiki.

I just went to the dealer and got 2 new gaskets for each block off plate. They are only a few bucks a piece...Its just the normal gaskets that go between the pipe and the egr valve and the intake mani..IMO, its better to use gaskets than gasket maker..

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)

well all is said and done, i made some blockoff plates and sealed them and bolted them back up, its lookin good now, I have to check it in the morning. Thanks for the advice though.


96 Talon ESi Mods
apex' dunk exhaust
injen short ram
magnecore 8.5mm wires
front/rear strut tower bars
custom painted interior
carbon fiber hood

I contributed to the Wiki.