My head gasket was leaking so I took the head off and I'm going to take it to a shop to get worked on. What should I have done to it? I have a decent amount of money so I would like to do whatever will help me while I have the head out. Port matched, 3 angle valve job, Port & Polished? I already have new springs, lash adjusters, and cam followers. Let me know what u all think. Thanks.

do the 3 angle and get it P&P....i ported my intkae manis today...well if ya gots money go for it.,.



Life is a bitch. Slap it around a little.

TURBO-HRC stage 1 Moddified

Howell Bottom end in room. Waiting to be unleashed.



email me at Anthonyl469@aol.com




"When you reach real ability you will be able to become one with the enemy. Entering his heart you will see that he is not your enemy after all." -Tjusii

1998 Integra Type R #0072

I wouldn't port the head unless you are stage 8 or so, our head flows beautifully stock. As for a valve grind, I would try to get a radius hone, but only if you really trust your machinist. Other then that, clean up and open up the ports a bit, but if you open them too much, you will lose velocity and the motor won't be terribly streetable. Maybe a set of billet cams? #14 off of Howell's site is best for most everybody who wants a daily driver. Cam gears, while the head is off, are easy to install. Other then that, since you upgraded the valvetrain (you did get PT Cruiser stuff, didn't you), there isn't a whole lot left to do, except maybe some stainless steel valves. Hope I was of help...
-=B-=

Dude, Boeing called. They want their wing back.

Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate.
Me: Can I put that in my sig?
Dark0ne95: GO right fucking ahead.