I was installing my SAFC and I noticed a block undernieth the gas pedal. I removed it and the pedal Moved considerably farther. I got the afc hooked up and looked at the throttle and it said 100% floored with the block out, so it had to be reading a ways under 100 since there was a like 1 inch difference. Let me know if anyone has done this. I didn't notice much of a difference but a good Idea I thought.

03 350Z
19"Volk GT-S, Greddy Twin Turbo, Greddy Exhaust
96 GS MT
S16g, Portfueler
Howell 2.2 Stroker

hmmm. Nope. U buy it new or used?

well it was purchased used, but the block was stock you can tell by the mounting hardware. a stud painted white with a nut. It rubber. I dont know but whatever it was its gone now. bye bye.

03 350Z
19"Volk GT-S, Greddy Twin Turbo, Greddy Exhaust
96 GS MT
S16g, Portfueler
Howell 2.2 Stroker

i know what you are talking about cuz whenever i had to replace my o2 sensor i had to remove the carpet and i saw it,so i checked it out, the gas pedal does not touch this, so it did you no good to take it off. just tryin to help thats all

hmmmmmmm mine was definatly touching but oh well it is gone now. Thanks though

03 350Z
19"Volk GT-S, Greddy Twin Turbo, Greddy Exhaust
96 GS MT
S16g, Portfueler
Howell 2.2 Stroker

as long as your throttle cable doesnt open the butterfly valve when not applyin pressure to gas peddle, and that it opens to completely horizontal or parallel w/ground at WOT or pedal to da floor, you shouldnt worry about whatever is behind it.

tia

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki

You could be over stressing the throttle cable and cause it to break which is a bad thing

1998 dodge avenger 4 cyl AT
Mods are:
Not enough