Ok well money is a little tight so my awful is on hold and I need a reliable DD. So here is what I have. A 1997 eclipse rs 5 speed. It runs but the engine I'm unsure of and would like to rebuild my one of my spare engines. It has a spun rod bearing.

So here is a list of parts I currently have.
Complete block and head
Good crank shaft
Good used stock pistons and rods
used cans and gears
Complete fel-pro gasket set
Ported stock intake
60mm Jeep TB
New belts
clevite main bearings
cai
Header
All new hoses and vacuum lines
Assembly lube
copper gasket spray

I need
Rod and can bearings
Lots of oil and filters
All new fluids ( break, anitfreeze, gear oil for trans)
Freeze plugs
Rings
Now I have access to a hot tank I can use for free. I need to hone theblock. This is just going to be a stock rebuild to freshen up the engine. I also have a head that jihads

97 RS blown engine

Sorry about that. I have a head I had cleaned and checked also milled. 010

97 RS blown engine