I noticed my cam sensor wiring is insanely stiff. So I bought a new pigtail to replace the old plug and wires. My question is this: Soldering or crimping. What is better? My concern is the heat of the EGR tube. I've read pros and cons of both methods, but it seems that crimping has the least amount of drawbacks (as long as it's done right).
#136672, "RE: Crimping or soldering?" In response to Reply # 1
On my Harley's {KNOWN 2-wheeled vibrators...........lol} I do both when the application permits. First I solder, then crimp, then re-heat solder to ensure optimum continuity. Then as a final touch, I usually cover connection w/heat-shrink tubing. The heat-shrink not only insulates, but adds a clean "pro" look. ** Note: make sure you slide heat-shrink on wire BEFORE soldering. **
The good we do, never remembered. The bad, never forgotten. _________ 97 Eagle Talon ESi w/CAI/HiPerf coil & wires/on-board G-force meter
Outside of Corona: "That sucks, peace out..." (jamie walks away)... "Sweeet, what we doin?" -Zac Tim's garage (prior to motor install): "Im gonna smoke real quick, that way if you fuck up I am already nicotined up" -Tim
#136676, "RE: Crimping or soldering?" In response to Reply # 3
That's sound advice. I can't tell you how many times I forgot to put heat shrink on before I had already soldered the connection.
OP - Just make sure you aren't caking your connections in solder. You only want to make a good connections, not drown the connections. If you haven't done much soldering in the past just practice on some lengths of wire before you start the actual job. It isn't hard.
When it comes to a sensor as critical to vehicle operation - and subject to so much heat and vibratory stress, I would ONLY consider soldering this thing on.
#136709, "RE: Crimping or soldering?" In response to Reply # 5
Originally posted by DR1665 Solder is always preferable. www.mmxpress.com/technical/connections.htm When it comes to a sensor as critical to vehicle operation - and subject to so much heat and vibratory stress, I would ONLY consider soldering this thing on. YMMV.
Driggs, that's a pretty cool article.
OP as you may know by now, it comes down to personal opinion. I prefer soldering rather than crimping.
#136913, "RE: Crimping or soldering?" In response to Reply # 0
you def want to solder any connection that will be exposed to the elements. dirt, oil, grease and water will get into a crimp connector and will corrode over time and lead to future problems. soldering take more time to do but will save you time and headache in the long run
Search
Printer-friendly copy
1 User in Chat
**
